R0106-HP MSR Router Series Voice Configuration Guide(V7)

89
configured by using the credentials command, and the credentials pass the authentication. The output
from the display voice sip register-status command shows that the phone number 1000 belongs to voice
entity 1.
<Sysname> display voice sip register-status
Number Entity Registrar Server Expires Status
--------------------------------------------------------------------------------
1000 1 192.168.4.240:5060 2877 Online
Configuring global SIP credentials
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter SIP view.
sip N/A
4. Configure global SIP
credentials.
user username password { cipher |
simple } password [ realm realm ]
By default, no global SIP credentials are
configured.
Configuring SIP credentials for a POTS entity
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter dial program view.
dial-program N/A
4. Enter POTS entity view.
entity entity-number pots N/A
5. Configure SIP credentials for
the POTS entity.
user username password { cipher |
simple } password [ cnonce cnonce
| realm realm ] *
By default, no SIP credentials are
configured for a POTS entity.
Enabling a POTS entity to register with the registrar
Perform this task to enable a POTS entity to register with the registrar. You can also disable a POTS entity
from registering with the registrar by using the undo register-number command if registration is not
needed.
To enable a POTS entity to register with the registrar:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter dial program view.
dial-program N/A
4. Enter POTS entity view.
entity entity-number pots N/A
5. Enable the POTS entity to
register with the registrar.
register-number
By default, a POTS entity registers
with the registrar after UA
registration is configured.