R0106-HP MSR Router Series Security Configuration Guide(V7)

137
[Router–GigabitEthernet2/1/2] portal bas-ip 20.20.20.1
[Router–GigabitEthernet2/1/2] quit
Verifying the configuration
# Verify that the portal configuration has taken effect.
[Router] display portal interface gigabitethernet 2/1/2
Portal information of GigabitEthernet2/1/2
IPv4:
Portal status: Enabled
Authentication type: Redhcp
Portal Web server: newpt
Authentication domain: Not configured
BAS-IP: 20.20.20.1
User Detection: Not configured
Action for server detection:
Server type Server name Action
-- -- --
Layer3 source network:
IP address Mask
Destination authenticate subnet:
IP address Mask
IPv6:
Portal status: Disabled
Authentication type: Disabled
Portal Web server: Not configured
Authentication domain: Not configured
BAS-IPv6: Not configured
User detection: Not configured
Action for server detection:
Server type Server name Action
-- -- --
Layer3 source network:
IP address Prefix length
Destination authenticate subnet:
IP address Prefix length
A user can perform portal authentication by using the HP iNode client or through Web page. Before
passing the authentication, the user can access only the authentication page
http://192.168.0.111:8080/portal. All Web requests from the user will be redirected to the authentication
page. After passing the authentication, the user can access Internet resources.
# After the user passes authentication, use the following command to display information about the
portal user.
[Router] display portal user interface gigabitethernet 2/1/2
Total portal users: 1
Username: abc
Portal server: newpt
State: Online