HP MSR4000 Router Series Installation Guide

Figure 21 Installing the MIM to the router

Installing a power supply

IMPORTANT:

• To install multiple power supplies, make sure all power supplies are AC input or DC input.

• Power supplies are hot swappable.

Installing an AC/DC power supply

1. Face the front of the router and locate the slot to be used.

2. Loosen the captive screws with a Phillips screwdriver to remove the filler panel from the slot.

Keep the removed filler panel for future use.

Skip this step if the power supply slot does not have a filler panel when the router is shipped.

3. Holding the handle of the power supply with one hand and supporting the bottom of the power

supply with the other hand, insert the power supply slowly along the slide rails until it makes close

contact with the backplane.

4. Use a Phillips screwdriver to fasten the captive screws on the two sides of the power supply.