HP MSR4000 Router Series Installation Guide

26
Figure 24 Removing the filler panel
3. Holding the handle of the power supply with one hand and supporting the bottom of the power
supply with the other hand, insert the power supply slowly along the slide rails until it makes close
contact with the backplane.
Figure 25 Installing a PoE power supply
4. Use a Phillips screwdriver to fasten the captive screws on the two sides of the power supply.
Connecting the router to the network
Connect the router to the network before powering on the router. This section describes how to connect
the router to the network through Ethernet cables.
Connecting an Ethernet cable
1. Plug one end of an Ethernet twisted pair cable into the copper Ethernet port (RJ-45 port) to be
connected on the router.
2. Plug the other end of the cable into the RJ-45 port of the peer device.