HP MSR4000 Router Series Telecommunications & Certification Manual

5
Canada – Industry Canada Compliance
CS-03 Compliance
The products listed below meet the applicable Industry Canada technical specifications.
Model Number
Description
HMIM 1VT1
1-port Voice T1 HMIM Module
HMIM 2VT1
2-port Voice T1 HMIM Module
HMIM 2T1
2-port T1 / CT1 / PRI HMIM Module
HMIM 4T1-F
4-port T1 / Fractional T1 HMIM Module
HMIM 8T1
8-Port T1/CT1/PRI MIM Module
HMIM 8T1-F
8-Port T1 / Fractional T1 MIM Module
HMIM 4FXS
4-port FXS HMIM Module
HMIM 16FXS
16-port FXS HMIM Module
HMIM 4FXO
4-port FXO HMIM Module
HMIM 8FXS8FXO
8-port FXS/8-port FXO HMIM Module
HMIM 4E&M
4-port E&M HMIM Module
NOTICE: The Industry Canada (IC) label identifies certified equipment. This certification means that the
equipment meets the telecommunications network protective, operational, and safety requirements as
prescribed in the appropriate Terminal Equipment Technical Requirements document(s). The department
does not guarantee the equipment will work to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities
of the local telecommunications company. The equipment must also be installed using an acceptable
method of connection. The user should be aware that compliance with the above conditions might not
prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier.
Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the equipment.
This equipment does not contain any parts that can be repaired by the user.
Users should ensure for their own protection that the electrical ground connections of the power utility,
telephone lines, and internal metallic water pipe system, if present, are connected together. This
precaution may be particularly important in rural areas. Caution: Users should not attempt to make such
connections themselves, but should contact the appropriate electrical inspection authority or electrician,
as appropriate.
The Ringer Equivalence Number (REN) is an indication of the maximum number of devices allowed to
be connected to a telephone interface. The termination on an interface may consist of any combination
of devices subject only to the requirement that the sum of the RENs of all the devices does not exceed
five.