HP MSR4080 Router FIPS Enclosure Installation Guide

The information contained herein is subject to change without notice.

Installing a FIPS enclosure on a router with rear mounting brackets

Face the rear panel, install the rear mounting brackets on both sides of the router and secure

them with M4 countersunk-head screws, mount the router on a rack shelf (skip this step if the

router is not to be mounted on a rack), and attach the opacity shield.

Install hex bolts on the chassis as shown in the figures. Align the holes on the opacity shields

with the hex bolts.

Only use the screws and hex bolts that are supplied in the opacity shield kit to secure

the opacity shield.

Press the opacity shields against the side

panels, and use M3 countersunk-head screws

to secure the opacity shields.

5998-3973