Brocade Fabric OS Command Reference Manual Supporting Fabric OS v7.0.0 (April 2011)

704 Fabric OS Command Reference
53-1001764-01
portCmd
22
-v vlan_id
Specifies the VLAN ID. Values must be in the range between 1 and 4094. There is
no default value. Note that a VLAN tag entry must exist on the local and remote
sides prior to issuing the -v option. A VLAN Tag table entry is dynamically
maintained by the ipperf application. See the portCfg help page for details on
creating a VLAN tag table.
-c L2 Class-of-Service
Specifies Class of Service/Priority, as defined by IEEE 802.1p. Valid values are 0
to 7. The default is 0. This operand is optional with the -v option
--ping
Pings a destination IP address from one of the source IP interfaces on the GbE
port. Valid arguments and their values include the following:
-s src_ip
Specifies the source IP address that originates the ping request. IPv6 addresses
are supported.
-d dst_ip
Specifies the destination IP address to which to target the ping request. IPv6
addresses are supported.
-x | -crossport
Specifies the source IP address as a crossport. A crossport is the nonlocal
(secondary) XGE port to a VE_Port group that provides failover capabilities for the
tunnel configured on the local XGE port. This operand is optional and supported
only on the Brocade FX8-24 XGE ports.
-n num_requests
Specifies the number of ping requests. Valid values are 1 to 255. The default is 4.
This operand is optional.
-q service_type
Specifies the type of service in the ping request. The default is 0 and service_type
must be an integer from 0 to 255. This operand is optional.
-t ttl
Specifies the time to live. Valid values are 1 to 255. The default is 100. This
operand is optional.
-w wait_time
Specifies the time to wait for the response of each ping request in milliseconds.
The default is 5000 ms and the maximum wait time is 9000 ms (9 seconds). This
operand is optional.
-z size
Specifies the default packet size to a fixed size in bytes. The default is 64 bytes. In
an IPv4 environment, the ICMP/IP header occupies 28 bytes. In an IPv6
environment it occupies 48 bytes. The total size, including ICMP/IP headers (28 or
48 bytes without IP options) cannot be greater than the IP MTU configured on the
interface. This operand is optional.
-v vlan_id
Specifies the VLAN ID. Values must be in the range between 1 and 4094. There is
no default value. Note that a VLAN tag entry must exist on the local and remote
sides prior to issuing the -v option. A VLAN Tag table entry is dynamically
maintained by the ipperf application. See the portCfg
help page for details on
creating a VLAN tag table.
-c L2 Class-of-Service
Specifies Class of Service/Priority, as defined by IEEE 802.1p. Values must
be in the range between 0 and 7. The default is 0. This operand is optional
with the -v option.