Brocade Web Tools Administrator's Guide - Supporting Fabric OS v7.0.0 (53-1002152-01, March 2012)
82 Web Tools Adminstrator’s Guide
53-1002152-01
Assigning a name to a port
6
Ingress rate limiting is applicable only to F_Ports and FL_Ports and is available only on the following
platforms:
• Brocade DCX
• Brocade DCX-4S
• Brocade DCX 8510
• Brocade Encryption Switch
• Brocade 300
• Brocade 5100
• Brocade 5300
• Brocade 5410
• Brocade 5424
• Brocade 5450
• Brocade 5460
• Brocade 5470
• Brocade 5480
• Brocade 6510
• Brocade 7800
• Brocade VA-40FC
• Brocade 8000
To configure the ingress rate limit feature, perform the following steps.
1. Select Port Admin > Advance Mode.
2. Select a port, or multiple ports, to configure.
3. Select the QoS Enable option.
This enables the QoS on selected ports. The selected port QoS status will be displayed in port
table.
4. Click the Edit Configuration button.
The Edit Configuration dialog displays. This dialog sets the QoS Ingress Rate Limit on selected
ports.
5. Configure the port using the pre-defined Ingress Rate Limits.
NOTE
You can set the Ingress Rate Limit even if QoS is disabled. It does not take effect until QoS is
enabled.
Assigning a name to a port
Port names are optional. You can assign a name to an FC or FCIP port to make port grouping
easier. You can also rename FC and FCIP ports to new names. You cannot rename GbE ports. The
Port Name column in the Ports tab displays the default port name.