HP B-series 16Gb FC Switches Hardware Reference Guide

Figure 16 Securing the switch (HP System/e Rack)
3. Tighten the hex nuts installed in stepStep 4.
4. Verify that the switch power and status LEDs on the port side of the switch are green. See
Figure 17 (page 30).
Figure 17 LEDs on port side
2. System status LED1. System power LED
4. FC port status LED (port 4)3. FC port status LED (port 0)
6. Ethernet port speed LED5. Ethernet port activity LED
5. Proceed to “Setting up the switch” (page 36).
This completes the rack mount procedure.
30 Installing and configuring HP 16Gb FC switches