Brocade iSCSI Gateway Service Administrator's Guide - Supporting Fabric OS v5.3.0 (53-1000440-01, June 2007)

12 iSCSI Gateway Service Administrator’s Guide
Publication Number: 53-1000440-01
Configuring the GbE interface
2
Arp configuration:
IP Address Mac Address
------------------------------
Iproute Configuration:
IP Address Mask Gateway Metric
------------------------------------------------------
switch:admin>
3. If Persistent Disable is set to ON, enter the portCfgPersistentEnable command with the slot
number and GbE port number.
switch:admin> portcfgpersistentenable 10/ge0
4. Enter the portCfgShow command with the slot number and GbE port number to verify that the
port is persistently enabled.
The Persistent Disable settings is set to OFF.
switch:admin> portcfgshow 10/ge0
Mode: ISCSI
Persistent Disable: OFF
Ipif configuration:
Interface IP Address NetMask MTU
----------------------------------------------------------
0 30.0.130.100 255.255.0.0 1500
Arp configuration:
IP Address Mac Address
------------------------------
Iproute Configuration:
IP Address Mask Gateway Metric
------------------------------------------------------
switch:admin>
Configuring the GbE interface
Configure the FC4-16IP GbE interface (TCP/IP) network settings and static IP routes. Use the
portCfg commands to perform the following tasks:
• “Assigning an IP address” on page 13
• “Adding static IP routes (optional)” on page 13
• “Verifying the network connection” on page 14
• “Adding ARP entries (optional)” on page 14
NOTE
You can set the TCP/IP parameters of a GbE port even when iSCSI gateway service is disabled.