HP Multimedia Sound Kit (D6657A), Installation Guide

1 Installing Your Multimedia Sound Kit
Step 1: Installing the CD-ROM Drive
8 English
9 Attach the data and power connectors to the rear of the CD-ROM
drive.
NOTE For Windows

3.11 users only. If you use the IDE cable connector
branching off the cable connected to the hard disk drive, move the pin
at the rear of the CD-ROM drive to enable the jumper labeled CS. In this
case, you must also disable 32-bit disk drive access, which you can do
via the Control Panel—refer to your Microsoft

Windows manual for
details of how to disable 32-bit access. You are recommended not to use
this option if you can instead use an available IDE data cable coming
direct from the system board.Step 2: Installing the Sound Board
d6657.book Page 8 Wednesday, February 3, 1999 5:38 PM