HP Multimedia Sound Kit (D6657A), Installation Guide

English 11

1 Installing Your Multimedia Sound Kit

Installing the Accessory Software

Windows 95

Installing the CD-ROM and Sound Board Drivers

NOTE HP recommends that the operating system be installed and functioning

fully before the board is installed in its slot.

Windows 95 automatically detects the CD-ROM drive and loads the

required software driver when you switch on your PC.

To install the sound board drivers, complete the following steps:

1 Switch on your PC. Windows 95 automatically detects the sound

board and displays the New Hardware Found, then Update the

Device Drive Wizard.

2 Insert the HP Multimedia Sound CD in the CD-ROM drive. (Insert

the CD label side up; press the open/close pushbutton to open and

close the drawer.)

3 Click on the Other Locations... button to locate the Windows 95

driver setup program on the CD-ROM. It is in the directory

d:\win95.

(The CD-ROM drive may be your E drive. In this case you would go

to e:\win95.)

4 Follow the instructions that are displayed on the screen.

5 Restart your computer.

Upgrading to Wave Table Quality

You can upgrade your MIDI playback to wave table quality by installing

the wave table software included on the CD-ROM.

To install the wave table software, complete the following steps:

1 With Windows 95 running, insert the HP Multimedia Sound CD in

the CD-ROM drive. (Insert the CD label side up; press the open/close

pushbutton to open and close the drawer.)

2 Click on the Start button, point to Settings, then click on Control

Panel.

d6657.book Page 11 Wednesday, February 3, 1999 5:38 PM