HP Multimedia Sound Kit (D6657A), Installation Guide

1 Installing Your Multimedia Sound Kit
Installing the Accessory Software
20 English
The driver software for the sound board is on your HP Multimedia
Sound CD.
If you already have OS/2 Warp installed with any embedded audio
driver on your system, you must uninstall the Multimedia Software
Support under OS/2, and then reinstall the Multimedia Software
Support. To do this:
1 With OS/2 running, double-click on the OS/2 System folder and then
double-click on the System Setup folder.
2 Double-click on the Selective Uninstall program.
3 Click on the box next to Multimedia Software Support, and then click
on the Uninstall button.
4 Click on the OK button, and then click on the Yes button.
5 At the confirmation message, click on the OK button and then the
Cancel button.
6 Shut down and restart the PC. (If an error message appears when
you restart the PC, see “To change the sound board settings at any
time, repeat this installation procedure. Do not use Selective Install.
If you change the sound board settings using Selective Install, you
may lose the sound functions. If this happens, reinstall the sound
board driver as described above.” on page 21.)
7 Double-click on the OS/2 System folder and then double-click on the
System Setup folder.
8 Double-click on the Selective Install folder.
9 Click on the icon next to the Multimedia Device Support option.
10 Click on the << Remove button to remove any audio drivers that are
in the right-hand-side window.
11 Click on the OK button. The System Configuration screen re-
appears. Check that None is selected under Multimedia Device
Support.
12 Click on the OK button, and make sure Multimedia Software Support
is selected.
13 Click on the Install button. Follow the instructions that appear on the screen.
14 Restart the PC.
d6657.book Page 20 Wednesday, February 3, 1999 5:38 PM