Neoware Thin Client - Thintune Operating System Manual

7.6.1 Configuration of the LAN Interface

7.6.1.1 General Network Settings tab

The settings in this section allows you to prepare THINTUNE for remote management and firmware updates

with THINTUNE Manager. Please be notified that for remote administration you need to install and

configure a firmware server. This will be a specified server to which THINTUNE connects to and checks for

new configurations or firmware versions. The software needed to install the firmware server can be

downloaded from the support section under

www.esesix-com.de.

Loopchecking If there are lots and small print jobs sent to THINTUNE, THINTUNE

might interprete this as a DoS-attack. In this case all printing-data will

be disregarded! To disable Loopchecking means that THINTUNE no

longer will check for DoS-attacks.

Proxy If the firmware server is located behind a proxy this dialog lets you

enter the proxie´s address.

Enable Management If checked this terminal remotely can be managed by THINTUNE

Manager.

Address/Port Determines the IP-address and the port of the Managementserver. This

value can be configured manually or by DHCP or by using the Assign-

option from THINTUNE Manager. For more details please refer to the

THINTUNE Manager manual.

Connection timeout (startup) On startup of the terminal this option lets you determine the number of

retries to establish communications between the terminal and the

Management server.

Use connection timeout After startup of the terminal this option lets you determine the number

of retries to establish communications between the terminal and the

Management server.