HP NetRAID Installation and Configuration Guide

Chapter 8 Upgrading to an HP NetRAID-3Si or HP NetRAID-1Si Adapter
112
6. Press any key and the HP NetRAID Express Tools utility starts
automatically. You see the Tools Management menu.
7. If you have more than one HP NetRAID Series adapter (including any
integrated HP NetRAID controller), do the following to select the adapter
you have just installed:
a. Choose Select Adapter from the Tools Management menu.
b. Choose the adapter with the mismatched configuration.
8. Choose Configure from the Tools Management menu.
9. Choose View/Add/Delete from the Configure menu.
10. Choose View Disk Configuration from the View/Add/Delete menu.
11. After scanning has finished, press ESC.
12. Choose Yes to save the configuration. The HP NetRAID Express Tools
utility now updates the configuration stored in NVRAM on the newly
installed adapter.
13. Press ESC repeatedly to exit HP NetRAID Express Tools.
14. Press CTRL+ALT+DELETE to restart the system. The new adapter
should recognize all the drives and the previous logical configuration.