HP NetRAID Installation and Configuration Guide

Chapter 9 Managing Servers Over the Network
120
6. Remove the HP NetServer Navigator CD-ROM and click Exit to restart
the HP NetServer.
Microsoft Windows NT or Windows 2000 Client or
Server Installation Instructions
For each client or server operating under Microsoft Windows NT or Windows
2000, or for each client running under Windows 95/98 or Windows 2000, run
Setup and then follow the on-screen instructions to install the appropriate
utilities.
All Windows NT, Windows 2000, and Windows 95/98 clients and servers should
be running the same versions of the HP NetRAID utilities supplied on the current
HP NetServer Navigator CD-ROM. If they are not running the same versions,
some clients and servers may not be able to communicate with each other.
Run Setup
To run the Setup program, follow the steps listed below either for Microsoft
Windows NT 4.0, Windows 2000, and Windows 95/98, or for Microsoft
Windows NT 3.51:
Step
Microsoft Windows NT 4.0,
Windows 2000, and
Windows 95/98
Microsoft Windows NT 3.51
1.
Select Start from the taskbar. Then
choose Run from the Start menu.
Select File/Run from the Program
Manager.
2. Insert Diskette 1 of " HP NetRAID
Software for Windows."
Insert Diskette 1 of " HP NetRAID
Software for Windows."
3. Type
<d>:\setup
at the Open
prompt, where
<d>
is the drive letter
of the diskette drive you are using.
Type
<d>:\setup
at the Run prompt
and click OK, where
<d>
is the drive
letter of the diskette drive you are
using.
4. Go to Step 5. Go to Step 5.