HP NetRAID Installation and Configuration Guide

Chapter 9 Managing Servers Over the Network
123
Novell NetWare Server Installation Instructions
NOTE All NetWare servers that contain HP NetRAID Series
adapters that will be managed by HP NetRAID Assistant
must be running the same version of HP NetRAID
Software for NetWare. Be sure to update any existing
installations.
The client or server managing these HP NetRAID
adapters must be running HP NetRAID Assistant version
A.02.02 or newer.
For each server operating under Novell NetWare and containing an integrated
HP NetRAID controller or HP NetRAID Series adapters to be managed over the
network, install HP NetRAID Software for NetWare as follows:
1. For NetWare 4.2 only, the file
rpcbstub.nlm
is a read-only file. This
file attribute must be changed to read/write before installing the
HP NetRAID Software for NetWare on a client connected to NetWare
through the network. Exit to the DOS prompt and change the file attribute
to r/w with the
attrib
command. The file is located in the
\system\
directory of NetWare on the
SYS
volume.
2. Start the NetWare server and insert the "HP NetRAID Software for
NetWare" diskette.
3. At the NetWare console prompt, type
load a:\raidinst.nlm
4. Choose Install Package.
5. To the question "Install registration server?" select yes or no.
◊ Select yes if you want this server to be the Registration Server.
◊ Select no if this server will not be the Registration Server. Enter the
name of the Registration Server when prompted.
6. Files are copied.
NOTE For NetWare 4.2, if you get the error message "Not able
to create SYS:SYSTEM\RPCBSTUB.NLM," go back to
Step 1 and change the file attribute to r/w.