HP NetRAID Installation and Configuration Guide

Chapter 10 Understanding HP NetRAID Utilities
132
HP NetRAID Config
HP NetRAID Config performs the same functions as HP NetRAID Assistant, but
it runs under Novell NetWare, SCO UnixWare, SCO OpenServer, and IBM
OS/2. HP NetRAID Config allows you to reconfigure and manage your RAID
system and monitor its status.
You do not need to reboot your HP NetServer to use HP NetRAID Config.
The command you use to start HP NetRAID Config utility depends on which
NOS you are using.
• For Novell NetWare, type
load megamgr
• For SCO UNIX, type
megamgr
• For SCO UnixWare, type
megamgr
• For SCO OpenServer, type
megamgr
• For IBM OS/2, type
megaconf
NOTE For internal mass storage in some HP NetServers, SCSI ID 5
is reserved for the SAF-TE processor that manages the hot-
swap mass storage cage.
For external mass storage, a SCSI ID may be reserved for a
SAF-TE processor. The number of the reserved SCSI ID
varies with the type of external enclosure.
The SAF-TE processor is displayed as PROC.
For a list of functions performed by HP NetRAID Config, see the menu chart that
follows.
For complete instructions on using HP NetRAID Config, see the HP NetRAID
Series User Guide.