HP NetRAID Installation and Configuration Guide

Chapter 12 HP NetRAID-3Si Battery Backup Unit
140
2. Choose Objects from the Tools Management menu.
3. Choose Battery Backup to view the battery status.
To Check Battery Status with HP NetRAID Config
1. Start HP NetRAID Config.
2. Choose Objects from the Management menu.
3. Choose Battery Backup to view the battery status.
Warnings That Battery Needs Replacement
• Power-up diagnostics include a battery life check. An on-screen message
alerts you if the battery life is low.
• HP NetRAID sends an SNMP error message that alerts you of the
condition.
Changing the Battery Backup Unit
Do not attempt to install a new Battery Backup Unit. If the battery needs to be
changed, call an HP Service Representative.
Connecting the Battery Backup Unit
The HP NetRAID-3Si adapter is shipped with the Battery Backup Unit installed
and charged, but disconnected. Follow the directions below to connect the Battery
Backup Unit.
CAUTION When the Battery Backup Unit is connected:
• Do not place the HP NetRAID-3Si adapter on a
conductive surface.
• When installing the adapter, do not allow the adapter or
its Battery Backup Unit to touch any part of the
HP NetServer. Doing so could short the battery, and it
may damage other components. You may place the
adapter on an antistatic mat.
The Battery Backup Unit is a battery pack already installed on the
HP NetRAID-3Si adapter. To connect the battery pack, plug the connector