HP NetRAID Installation and Configuration Guide

Chapter 13 Monitor Alert List
144
IBM OS/2 Monitor Messages
Table 13-2. OS/2 Monitor Messages
Condition Messages
Logical drive state
change
Adp = # LogDrv # state changed from (previous state)
to (new state).
Physical drive state
change
Adp = # PhysDrv at Ch # Tid # state changed from
(previous state) to (new state).
Monitor started HP NetRAID Monitor for OS/2
Memory allocation
failure
Malloc Failure
Adapter not identified No HP NetRAID Adapters Found
Adapter rebuild
completed X%
Adp = # Rebuilding Ch# Tid # Percent Rbld = X
SCO OpenServer and UnixWare Monitor Messages
Table 13-3. SCO OpenServer and UnixWare Messages
Condition Messages
Monitor starts HP NetRAID Monitor activated
Monitor deactivated HP NetRAID Monitor deactivated
No adapter found No HP NetRAID adapter found
Adapter inquiry failed HP NetRAID inquiry failed for adapter x
Physical drive state
change
Adapter: # PDrv Channel: SCSI ID # state change from
(previous state) to (new state).
Physical drive rebuilding
(when monitor starts)
Adapter: # PDrv Channel: SCSI ID# At startup is in
Rebuild state
Rebuild percentage
completed
Adapter: # PDrv Channel: SCSI ID# Rbld X% over
Rebuild failed Adapter: # PDrv Channel: SCSI ID# Rbld failed
Rebuild over (completed) Adapter: # PDrv Channel: SCSI ID# Rbld over
Logical drive state
change
Adapter: # LDrv # state change from (previous state) to
(new state).
Logical drive state at
startup
Adapter: # LDrv # state at startup is (current state)