HP NetRAID Installation and Configuration Guide

Chapter 15 Troubleshooting

148

Configuration of NVRAM and drives mismatch

Run View/Add Configuration option of Configuration Utility.

Press any key to enter the Configuration Utility.

Problem: There is a single adapter, and the configuration stored in the adapter’s

NVRAM does not match the configuration stored in the drives. All drives contain

one set of configuration information, and NVRAM contains a different set.

Suggested solution: Do the following to pick the correct configuration from either

NVRAM or from the disks.

1. Press any key to enter HP NetRAID Express Tools.

2. From the Configure menu, choose the View/Add Configuration option.

View/Add Configuration asks which configuration you want to view:

NVRAM or disk.

3. Use View/Add Configuration to examine both configurations.

4. Resolve the configuration mismatch by selecting and saving one of the

two configurations.

Configuration of NVRAM and drives mismatch for Host Adapter - x

Run View/Add Configuration option of Configuration Utility.

Press any key to enter the Configuration Utility.

Problem: You have installed more than one adapter, and the configuration stored

in NVRAM of adapter x does not match the configuration stored in the drives.

All drives on that adapter contain one set of configuration information, and

NVRAM contains a different set.