HP NetRAID Installation and Configuration Guide

Appendix D Cabling Diagrams
177
HP NetServer LH Pro and LH II
CAUTION To remove or install mass storage cables to an HP NetRAID
Series adapter in this HP NetServer, you must first remove
the power supply(s). Follow the procedures in your system’s
road map or in Information Assistant to successfully remove
and replace the power supplies. Failure to follow these
procedures may result in breaking the power management
board.
Non-Duplex Cabling
T
C11
C22
C23
B1
B1
C14
C22
CH0
HP NetRAID-1Si Adapter
IC
2
SCSI A
SCSI B
Ext. Conn.
System Board
IDE
A
T
Flexible Disk
Drive
CD-ROM
Drive
SCSI or IDE
Device
(Rear View)
Route this cable through the rear access hole
located below the HP NetServer system board.
Figure D-6. Non-Duplex Cabling of HP NetServer LH Pro or LH II with an
HP NetRAID-1Si Adapter