HP NetRAID Installation and Configuration Guide

Appendix D Cabling Diagrams
180
HP NetServer LPr
SCSI Cable as Originally Configured
Hard Disk
Drive
SCSI
Backplane
I/O Board
SCSI Controller
SCSI Cable with
Connectors A, B, and C
SCSI Repeater
Card
Hard Disk
Drive
A
B
C
Figure D-8. NetServer LPr SCSI Cable When Not Configured for HP NetRAID
Figure D-8 shows how the SCSI cable is connected in the NetServer LPr. The
next figure shows where these connectors appear in the NetServer LPr.
As seen in Figure D-10, to connect the two internal drives to a HP NetRAID
Series adapter, you will need to move the two connectors labeled "B" and "C."