HP NetRAID Installation and Configuration Guide

Appendix D Cabling Diagrams
183
HP NetServer LXe Pro
Non-Duplex, Disk Array
CAUTION The HP NetServer LXe Pro comes with one power supply
module. Do not attempt to run the HP NetServer with any
mass storage devices installed in the right side (including
shelves B1 or B2, illustrated below) without first installing a
second power supply module. Installing any mass storage
devices on the right side requires the addition of a second
power supply module.
**
**
*
*
Flexible
Disk
Connectors
CH0
HP NetRAID-1Si Adapter
System
Board
SCSI A
SCSI B
Rear Panel
Connector
Right Cages
Rear View
Left Cages
Rear View
SCSI or IDE
Device
B1 A1
B2 A2
Flexible
Disk Drive
CD-ROM
Drive
Termination resistor is
incorporated into cable.
Backplane terminates
automatically if no
cable is connected.
C13
C12
C14
C11
C15
A
Figure D-11. Non-duplex, Disk-Array Cabling of HP NetServer LXe Pro with
an HP NetRAID-1Si Adapter