HP NetRAID Installation and Configuration Guide

Index
203
Rebuild
operation, 195
status of SCSI disk, 196
Rebuild rate, 38, 195
planning, 38
setting or verifying, 57
Rebuilding state of physical drive, 56
Reclaim button
for hot spare, 61
Recreate a configuration, 108
Redundancy check box, 59
Regulatory information, 161
Remote management, 113
Rescan, 58
Reset (clear) configuration, 56
Restore data, 196
Roaming, disk, 7
S
SAF-TE processor, 163, 196
Save binary file, 67
Scatter/Gather, 6
SCSI cables
illustration of connections, 186, 188
SCSI channels
HP NetRAID, 196
physical drives on, 56
SCSI Channels
planning, 33
SCSI disk status, 196
SCSI ID
in HP NetRAID, 196
of physical drive, 56
SCSI transfer rate, 84
Set PCI class code, 74, 84, 85
SIMMs, Cache Memory, 5
Slot Selection, 29
Span Arrays check box, 62, 64
Spanning arrays, 64
Starting
HP NetRAID Access Service, 125
HP NetRAID Assistant, 125
HP NetRAID Express Tools, 84
States of physical drives, 56
Static electricity, 10, 45, 51, 108
Step A. Plan Your Hardware, 27
Step B. Plan Arrays and Logical
Drives, 34
Step C. Prepare the Adapter, 45
Step D. Install the Adapter, 49
Step E. Install Cables and Set SCSI
Switches, 51
Step F. Start HP NetServer Navigator
to Launch HP NetRAID Assistant,
53
Step G. Configure Arrays and Logical
Drives, 54
Step H. Save Configuration and
Initialize, 67
Step I. Decide I
2
O or Non-I
2
O, 73
Step J. Use the HP NetServer Navigator
CD-ROM to Prepare Diskettes, 74
Step K. Install NOS and HP NetRAID
Drivers, 79
Step L. Install NOS-specific
Configuration Utility, 81
Step M. Run HP NetRAID Express
Tools, 83
Step N. Prepare for Online Capacity
Expansion, 87
Stripe size (depth)
HP NetRAID, 196
planning, 41
setting, 63
Stripe width, 197
Striping, 196
Support, 158
T
Tagged Command Queuing, 6
Tools, 10