HP NetRAID Installation and Configuration Guide

Chapter 5 Installation and Configuration
49
Step D. Install the Adapter
In this step, you will:
• Turn off the HP NetServer and remove the necessary covers or open the
panels
• Install the adapter
Turn Off the HP NetServer and Open It
CAUTION HP NetRAID Series Accessory boards are not hot pluggable.
Unplug HP NetServer power cord(s) before installing a
HP NetRAID Series board.
NOTE Before you begin, you may need to look up information about
your HP NetServer in Information Assistant on the
HP NetServer Documentation CD-ROM. You will need to
know how to open or remove the HP NetServer panels and
covers, as well as any special instructions for installing a
board in a PCI slot of the HP NetServer.
Turn off the HP NetServer and open it, as follows:
1. Bring down the operating system properly, as described in your
NOS documentation.
2. Turn off the HP NetServer power and disconnect the power cord(s) and all
telephone cords.