HP NetRAID Installation and Configuration Guide

Chapter 6 HP NetRAID Software
77
Using the HP NetServer to Create Drivers Diskette and Instructions
To use the HP NetServer you are configuring to create the diskette(s) containing
the drivers for your NOS and the instructions for installing the NOS, do the
following:
1. Turn on the HP NetServer and monitor, if they are not already on, and
insert the HP NetServer Navigator CD-ROM into the drive. Turn off the
HP NetServer power, wait 10 seconds, and turn it back on again.
2. From the HP Navigator Main Menu, choose Configuration and
Installation Assistant.
3. From the Configuration Assistant menu, choose Custom.
4. From the Gather Information window, choose your NOS. If necessary,
also select your version of the NOS.
5. When you see the message, "Would you like to use HP’s automated mode
of NOS installation?" click No.
6. From the Custom Configuration menu, choose Create Driver
Diskette(s).
7. From the Create Driver Diskette(s) window, choose Create Driver
Diskette(s). Select the diskette to create, click Execute, and follow the
onscreen instructions.
8. When the driver diskette is complete, click Back to return to the Custom
Configuration menu.
9. From the Custom Configuration menu, choose Show NOS Installation
Instructions.
10. On the Show NOS Installation Instructions window, click Save to Disk.
Later in Step J, you will print the Network Operating System Installation
Instructions.
11. Click Back to return to Configuration Assistant, and click Back again to
return to the Main Menu.