HP NetRAID Installation and Configuration Guide

Chapter 6 HP NetRAID Software
83
3. Type cd\ and press the Enter key.
4. Type md NetRAID and press the Enter key.
5. Type cd NetRAID and press the Enter key.
6. Insert the diskette containing the HP NetRAID drivers for IBM OS/2.
7. Type copy <d>:\netraid\*.* and press the Enter key, where <d>
is the diskette drive.
8. Type megaconf.exe from the NetRAID directory to run the
HP NetRAID Config utility.
Novell NetWare 4.2 and 5
1. Exit to the DOS prompt.
2. Insert the diskette called " HP NetRAID Software for NetWare."
3. Type
Copy <d1>:\NetRAID\*.* <d2>:\nwserver
, where
<d1>
is the drive letter for the diskette drive and
<d2>
is the hard disk where
NetWare is installed. Press Enter.
4. To load the HP NetRAID Config utility, type
load <d2>:\nwserver\megamgr.nlm
and press Enter at the
NetWare console prompt.
SCO OpenServer 5.0.x and UnixWare 7.0
No instructions are necessary. The HP NetRAID Config utility was installed
automatically when you installed the HP NetRAID driver.
Step M. Run HP NetRAID Express Tools
After you have installed your software, you may need to run the HP NetRAID
Express Tools utility. Run HP NetRAID Express Tools if you need to do any of
the following:
• If you are using either Fast/Wide or Ultra/Wide devices in an external
mass storage enclosure, set the SCSI transfer rate.
◊ The default SCSI transfer rate is Ultra2.
◊ The alternative SCSI transfer rates are Fast and Ultra.
◊ Change the SCSI transfer rate for the external channel to match the
external devices or external enclosure.