HP NetRAID Installation and Configuration Guide

Chapter 6 HP NetRAID Software
85
• HP NetRAID-3Si (D5955A)
• HP NetRAID-1Si (D2140A)
To disable the HP NetRAID BIOS for all adapters in the system, choose Disable
BIOS from the Tools Management menu.
To Change the SCSI Transfer Rate
1. If you have installed one or more HP NetRAID Series adapters, select the
adapter controlling the SCSI channel on which Fast/Wide or Ultra SCSI
support is to be enabled:
◊ Choose Select Adapter from the Tools Management menu.
◊ Select the adapter controlling the SCSI channel of interest.
2. Choose Objects from the Tools Management menu.
3. Choose SCSI Channel from the Objects menu.
4. Select the channel on which the SCSI transfer rate is to be changed.
5. To change the SCSI transfer rate:
◊ Choose SCSI Transfer Rate from the SCSI Channel menu. A
submenu appears.
◊ Use the arrow keys to highlight your selection: Fast, Ultra, or Ultra2.
Press Enter.
◊ Choose Yes to confirm your selection.
6. Press Esc to return to the Tools Management menu.
To Change the PCI Class Code to I2O
To support I
2
O operation, set the PCI class code to I2O on all HP NetRAID
Series adapters in the system, other than HP NetRAID and HP NetRAID-1
adapters (which do not support I
2
O). Also set it to I2O for the integrated
HP NetRAID controllers, if present.
NOTE Instead of using HP NetRAID Express Tools to change the
PCI class code, you can use the Set Class utility in the "
HP NetRAID Software for DOS" utility in the diskette library
on the HP NetServer Navigator CD-ROM. This is faster if you
have multiple HP NetRAID Series adapters because it avoids
multiple restarts of the HP NetServer.