HP NetRAID Installation and Configuration Guide

Chapter 6 HP NetRAID Software
86
To use HP NetRAID Express Tools to change the PCI class code, do the
following:
1. If you have installed one or more HP NetRAID Series adapters, select the
integrated controller or an adapter:
◊ Choose Select Adapter from the Tools Management menu.
◊ Select the adapter of interest.
2. Choose Objects from the Tools Management menu.
3. Choose Adapter from the Objects menu.
4. Choose Emulation from the Adapter menu.
5. To change the PCI class code:
◊ Use the arrow keys to highlight I2O. Press Enter.
◊ Choose Yes to confirm your selection.
6. Restart the HP NetServer when prompted.
To Exit HP NetRAID Express Tools
To exit HP NetRAID Express Tools, press Esc repeatedly until the Exit? prompt
is displayed. Choose Yes. Then press any key to reboot. The new parameters
become effective after you reboot.
Run Other Utilities, If Necessary
You may need to enable or disable ports or change settings such as IRQs or MP
specifications. To do so, run the utility appropriate for your system, such as:
◊ Setup Utility
◊ EISA Configuration Utility (ECU)
Refer to your HP NetServer documentation for instructions.