HP NetRAID-4M Configuration and Upgrade Guide (Release 5)

Chapter 8 Internal Cabling

3. Insert the new cable through the opening of the mid-plane divider and pull it to

the other side.

4. Connect one end of the new SCSI cable to the internal LVD/SE connector on the

HP NetRAID-4M. Push the connector until it clicks into place.

5. Connect the other end of the cable to the 68-pin connector on the right-side hot-

swap cage. Push the connector until it clicks into place.

6. Ensure that all cables are out of the way, and then replace the system cover.

7. After all covers have been replaced and secured, reconnect the power cord and

all external cables, as described in your documentation.

HP Netserver LXr 8000/LXr 8500

For the latest information go to HP’s web site at:

http://netserver.hp.com/