HP NetRAID-4M Configuration and Upgrade Guide (Release 5)

Chapter 8 Internal Cabling
30
2. Remove the system cover. (Refer to the HP Netserver LC 2000/2000r
Installation Guide.)
3. Install the HP NetRAID-4M in a PCI slot. (Refer to the documentation supplied
with the HP NetRAID-4M for more detailed instructions.)
4. Install the new SCSI cable.
5. Connect the non-terminated end of the new SCSI cable to the internal LVD/SE
connector on the HP NetRAID-4M. Push the connector until it clicks into place.
6. Connect the terminated end of the cable that has the terminator block with the
devices located in the Common Tray. (Start with the connector at the terminated
end of the cable).
7. Ensure that all cables are out of the way—then replace the system cover.
8. After all covers have been replaced and secured, reconnect the power cord and
all external cables, as described in your documentation.