HP NetRAID-4M Configuration and Upgrade Guide (Release 5)

Chapter 8 Internal Cabling

HP Netserver LH 3000/LH 6000: Installing the

New SCSI Cable

Connecting Common Tray Devices

Connect the new SCSI cable (5185-2359) to the devices in the Common Tray as

shown in Figure 8-2:

Figure 8-2. HP Netserver LH 3000/LH 6000 Common Tray Cabling*

*The slot location shown in Figure 8-2 is for illustration only. Other slot locations

will work. (For maximum performance, install your HP NetRAID-4M in a 64-bit

slot.)

1. Remove the server from the rack enclosure. (Refer to the HP Netserver LH

3000/3000r Installation Guide or HP LH 6000/6000r Installation Guide and to

your rack documentation.)

2. Remove the system cover. (Refer to the HP Netserver LH 3000/3000r

Installation Guide or HP LH 6000/6000r Installation Guide.)

3. Install the HP NetRAID-4M in a PCI slot. (Refer to the documentation supplied

with the HP NetRAID-4M for more detailed instructions.)

4. Install the new SCSI cable.

5. Connect the non-terminated end of the new SCSI cable to the internal LVD/SE

connector on the HP NetRAID-4M. Push the connector until it clicks into place.

Power

Supply

Terminator

Clip

Floppy Drive

CD-Rom

Bay 1

Bay 2

HBA

PSI Slot