Integrated HP NetRAID Controller Config. Guide

Chapter 10 Understanding HP NetRAID Utilities
134
HP NetRAID Config
HP NetRAID Config performs functions similar to those of HP NetRAID
Assistant, but it runs under Novell NetWare, IBM OS/2, SCO OpenServer, and
SCO UnixWare. HP NetRAID Config allows you to reconfigure and manage your
RAID system and monitor its status.
You do not need to restart your HP NetServer to use HP NetRAID Config.
The command you use to start the HP NetRAID Config utility depends on which
NOS you are using.
• For Novell NetWare, type load megamgr
• For SCO UnixWare, type megamgr
• For SCO OpenServer, type megamgr
• For IBM OS/2, type megaconf
NOTE For internal mass storage in HP NetServer LH 3000/3000r,
LH 6000/6000r, and LT 6000r, SCSI ID 5 is reserved for the
SAF-TE processor that manages the hot-swap mass storage
cage.
For an external mass storage enclosure with a SAF-TE
processor, a SCSI ID is reserved for that processor. The
number of the reserved SCSI ID varies with the type of
external enclosure.
The SAF-TE processor is displayed as PROC.
For a list of functions performed by HP NetRAID Config, see the menu chart that
follows.
For complete instructions on using HP NetRAID Config, see the HP NetRAID
Series User Guide.