Integrated HP NetRAID Controller Config. Guide

Chapter 11 Troubleshooting
143
Insufficient Memory to Run. Press any Key to Continue ...
Problem: There is insufficient memory in the HP NetServer to run the
HP NetRAID BIOS.
Suggested solution: Check the HP NetServer to be sure that the memory is
properly installed.
• For HP NetServer LH 3/3r and LH 4/4r, it is the SIMM on the I/O board.
• For HP NetServer LH 3000/3000r, LH 6000/6000r, and LT 6000r, it is the
DIMM on the I/O board.
Insufficient Memory
Problem: There is insufficient memory for the current configuration.
Suggested solution: Check to be sure that the memory is properly installed.
• For HP NetServer LH 3/3r and LH 4/4r, it is the SIMM on the I/O board.
• For HP NetServer LH 3000/3000r, LH 6000/6000r, and LT 6000r, it is the
DIMM on the I/O board.
Following SCSI ID’s are not Responding
Channel-x:a.b.c
Problem: On the channel listed (x), the physical drives with the SCSI IDs listed
(a, b, c, and so on) are not responding.
Suggested solution: Verify that the physical drives are connected and powered
on.
Other BIOS Error Messages
Error: Following SCSI Disk not found and No Empty Slot Available for mapping it
Problem: The physical disk roaming feature failed to find the physical drive with
the listed SCSI ID, and no slot is available in which to map the physical drive.
The controller cannot resolve the physical drives into a current configuration.
Suggested solution: Reconfigure the array because the adapter cannot resolve the
physical drives into the current configuration.