Integrated HP NetRAID Controller Config. Guide

Chapter 11 Troubleshooting

146

Could Not Configure the i960 I/O Processor's PCI Subsystem IDs

NOTE This error message only occurs in HP NetServer

LH 3000/3000r, LH 6000/6000r, and LT 6000r.

Problem: Error message, "could not configure the i960 I/O processor's PCI

subsystem IDs." The HP NetRAID DIMM may not be fully seated, or the

integrated HP NetRAID firmware is corrupt.

Suggested solution: Ensure that the HP NetRAID DIMM on the I/O board is

seated correctly. If that does not solve the problem, see the "Firmware Is Not

Valid!" problem below.

Firmware Is Not Valid!

NOTE This error message only occurs in HP NetServer

LH 3000/3000r, LH 6000/6000r, and LT 6000r.

Problem: Error message, "Firmware is not valid! See readme on 'Integrated

HP NetRAID Firmware Update" diskette..." The integrated HP NetRAID

firmware is corrupt.

Suggested solution: See the Readme file on the "Integrated HP NetRAID

Firmware Update" diskette in the diskette library on the HP NetServer Navigator

CD-ROM. Press any key to continue.

Firmware Continues to Initialize

Problem: "Firmware Initializing..." appears and remains on the screen.