Integrated HP NetRAID Controller Config. Guide

151
A Integrated HP NetRAID Controller
Specifications
In HP NetServer LH 3/3r and LH 4/4r
Table A-1. Specifications for Integrated HP NetRAID Controller in
HP NetServer LH 3/3r and LH 4/4r
Parameter Specification
Processor Intel i960RD @ 66 MHz
Bus Type PCI 2.1 or PCI 2.2
Bus Data Transfer Rate Up to 132 MB/sec
BIOS HP NetRAID BIOS
Cache Configuration 16 MB using 50 ns EDO DRAM
Firmware 1-MB flash ROM
Nonvolatile RAM 32-KB NVRAM for disk configuration space
SCSI Controllers Symbios Logic 53C895 on each channel
SCSI Data Transfer Rate Up to 80 MB/sec with Ultra2 drives
SCSI Bus Low voltage differential or single-ended SCSI
SCSI Termination Active
Devices per SCSI Channel 6 to 8, depending on SCSI mode and storage cabinet
SCSI Device Types
Supported
Low voltage differential drives in the mass storage cage
or non-hot-swap, single-ended SCSI disk drives
Hot-swap SCSI Channels One or two
RAID Levels Supported 0, 1, 3, 5, 10, 30, and 50
SCSI Connectors 68-pin, high-density internal connectors
HP NetRAID Series
adapters
Up to six HP NetRAID Series adapters per system, including the
integrated HP NetRAID adapter (counts as one adapter)