Integrated HP NetRAID Controller Config. Guide

5 Configuration

Overview

This chapter covers Steps C, D, E, F, and G of the installation procedure. You

should already have completed Step A, "Plan Your Hardware," and Step B, "Plan

Arrays and Logical Drives," in Chapter 4.

Step C. Verify Hardware Setup

Verify that your hardware setup matches the plans you sketched in Worksheet A.

Make sure of the following:

• You have installed and connected all additional hardware that you plan to

use, such as a duplex board, second mass storage cage, or external mass

storage enclosure

• Disk drive modules are inserted in the hot-swap mass storage cage(s)

NOTE For HP NetServer LH 3/3r and LH 4/4r, make sure the SCSI

IDs of the non-hot-swap devices on the SE SCSI connector do

not conflict with the SCSI IDs of the hot-swap disk drive

modules connected to SCSI B.

Step D. Run Setup Utility

Run the Setup utility to do the following:

• For HP NetServer LH 3/3r and LH 4/4r, use the Setup utility to enable the

integrated HP NetRAID controller and to designate the channels it

controls. Refer to "For HP NetServer LH 3/3r and LH 4/4r, Run Setup

Utility" in this chapter.

• For HP NetServer LH 3000/3000r, LH 6000/6000r, and LT 6000r, use the

Setup utility to put SCSI channels A and B under control of the integrated

HP NetRAID controller. Refer to "For HP NetServer LH 3000/3000r,

LH 6000/6000r, and LT 6000r, Run Setup Utility" in this chapter.