Integrated HP NetRAID Controller Config. Guide

Chapter 5 Configuration
48
For HP NetServer LH 3/3r and LH 4/4r, Run Setup Utility
The HP NetServer factory default setting enables the integrated HP NetRAID
controller for the SCSI A port only. Use the Setup utility to verify this setting, or
to enable the integrated HP NetRAID controller for the SCSI B port as well.
CAUTION If you ever use the Setup (F2) utility to reset to system
defaults, the configuration that records which HP NetRAID
channels are enabled or disabled will also be reset to its
default value. The default HP NetRAID configuration enables
integrated HP NetRAID and includes SCSI A only.
If you have changed the HP NetRAID configuration in the
Setup utility, and then you reset to system defaults, you must
re-enable the correct HP NetRAID channels before you exit
the Setup utility.
1. Turn on the power to the HP NetServer and display monitor.
If you receive an error message during the boot process, refer to your
HP NetServer's installation guide, to the online help in Information
Assistant, or to Chapter 11, "Troubleshooting," in this guide. Some
power-up (boot) messages are routine.
NOTE The message "Configuration of NVRAM and drives
mismatch" indicates that configuration information in the
integrated HP NetRAID controller's NVRAM differs from
configuration information of the hard disk drives.
1. Press <Ctrl> <M> to start the HP NetRAID Express Tools
utility.
2. On the Tools Management Menu, choose Configure.
3. On the Configure menu, choose View/Add/Delete
Configuration.