Integrated HP NetRAID Controller Config. Guide

Chapter 5 Configuration
49
4. View the configuration in NVRAM to decide whether it is
correct. Press Esc. You are asked if you want to save the
configuration.
• If the NVRAM configuration is correct, answer Yes to
save it. Go to Step 7.
• If the NVRAM configuration is not correct, answer No.
5. View the configuration in the drives. Press Esc.
• If the drives configuration is correct, answer Yes to save
it. Go to Step 7.
• If the drives configuration is not correct, answer No.
• If neither configuration is correct (or if you tried the steps
above and the configuration mismatch persists), follow
Steps 6, 7, and 8 to clear configuration information from
integrated HP NetRAID NVRAM and exit. Then restore
from a backup.
6. On the Configure menu, choose Clear Configuration.
• If the question "Clear Configuration?" is displayed,
answer Yes. Then press any key to continue, and go to
Step 4 in this note.
• If the message "No Existing Configuration to Clear" is
displayed, press Esc to return to the Configuration menu,
choose New Configuration, and answer Yes to the
"Proceed?" question. When the scan finishes, all drives
are shown in the Ready state. Press Esc to end the array,
and answer Yes to the "Save Configuration? question.”
When "Configuration is Saved" is displayed, press any
key.
7. To exit HP NetRAID Express Tools, press Esc repeatedly
until the Exit? box appears. Choose YES to exit.
8. Press <Ctrl> <Alt> <Del> to restart the NetServer.
2. Press the F2 function key when you see this message:
Press <F2> to enter SETUP