Integrated HP NetRAID Controller Config. Guide

Chapter 5 Configuration

3. If a password has been set, provide it when prompted.

4. When the Setup Utility menu is displayed, the settings for the integrated

HP NetRAID controller are:

• Integrated HP NetRAID [Enable/Disable]

This setting enables or disables the integrated HP NetRAID controller

for both SCSI ports. To use the HP NetRAID controller, this setting

must be set to Enable.

• Included SCSI_A Channel [Yes/No]

If the integrated HP NetRAID controller is enabled, this setting

selectively includes or excludes SCSI port A from the HP NetRAID

subsystem.

• Included SCSI_B Channel [Yes/No]

If the integrated HP NetRAID controller is enabled, this setting

selectively includes or excludes SCSI port B from the HP NetRAID

system.

CAUTION If a channel was previously operating in non-RAID SCSI

mode, changing to RAID mode (integrated HP NetRAID

enabled and the channel included) could cause data loss. Be

sure your data is backed up before you change to RAID mode.

If your HP NetServer was previously operating in RAID

mode, changing to non-RAID mode could cause data loss. Be

sure your data is backed up before you change to non-RAID

mode.

NOTE If you enable HP NetRAID for just one SCSI channel, that

becomes the integrated HP NetRAID Channel 0. If you enable

both SCSI channels, SCSI A becomes Channel 0, and SCSI B

becomes Channel 1.

5. If necessary, you can use the Setup utility to change settings such as the

boot order.

6. Press the F10 function key to save and exit.