Integrated HP NetRAID Controller Config. Guide

Chapter 5 Configuration

11. The Embedded LAN and SCSI Settings submenu is displayed. If

HP NetRAID/LVD SCSI is not already highlighted, use the up and down

arrows to highlight it.

Read the values in the brackets to determine whether HP NetRAID is

enabled.

◊ Enable LVD SCSI indicates that LVD SCSI is enabled and

HP NetRAID is disabled. This is the setting for non-RAID operation

of the mass storage connected to SCSI A and B on the I/O board.

◊ Enable HP NetRAID indicates that HP NetRAID is enabled to

provide RAID operation of the mass storage connected to SCSI A and

B on the I/O. This is the default value.

CAUTION If your HP NetServer was previously operating in non-RAID

mode (Enable LVD SCSI), changing to RAID mode (Enable

HP NetRAID) could cause data loss. Be sure your data is

backed up before you change to RAID mode.

If your HP NetServer was previously operating in RAID mode

(Enable HP NetRAID), changing to non-RAID mode (Enable

LVD SCSI) could cause data loss. Be sure your data is backed

up before you change to non-RAID mode.

If the value is not Enable HP NetRAID, use the +/- keys to change it to

Enable HP NetRAID. This change will take effect when the

HP NetServer restarts.

Exit Setup Utility

12. Press the F10 function key to save and exit.

13. In the Setup Confirmation dialog box, press Enter to answer "Yes" to the

question, "Save configuration changes and exit now?" The HP NetServer

will restart.