Integrated HP NetRAID Controller Config. Guide

Chapter 5 Configuration

Step E. Launch HP NetRAID Assistant

Start HP NetServer Navigator CD-ROM

To launch HP NetRAID Assistant, start the HP NetServer that you are

configuring from the HP NetServer Navigator CD-ROM. Ensure that all the

external SCSI devices power up before or at the same time as the host computer.

Boot Messages

If you receive an error message during the boot process, refer to your

HP NetServer's installation guide, to the online help in Information Assistant, or

to Chapter 11, "Troubleshooting," in this guide. Some power-up (boot) messages

are routine.

Select Configure Disk Array

If HP Navigator asks you to set the date, time, and so on, do so. The HP

Navigator Main Menu then appears.

1. When the HP Navigator Main Menu is displayed, choose NetServer

Utilities.

2. Choose Disk Array Utility from the NetServer Utilities screen. This

launches the HP NetRAID Assistant utility.

Step F. Configure Arrays and Logical Drives

In this step, you will use Worksheets A and B to:

• Configure the arrays of physical drives

• Configure the logical drives