Integrated HP NetRAID Controller Config. Guide

Chapter 5 Configuration
62
Define Physical Arrays and Dedicated Hot Spares
NOTE Refer to Worksheet A when defining arrays.
The HP NetRAID Assistant Wizard Array Definition window appears, displaying
the Physical Devices and Logical Devices configured on your system. It will be
similar to the display shown in Figure 5-4 depending on your configuration. The
"new array" in the Logical Devices box shows where a new array can be defined.
Figure 5-4. HP NetRAID Assistant Wizard Array Definition Window
To assign physical drives to the first array:
1. Select all the Ready physical drives that you want to put into the first
array. Clicking on a drive either selects or deselects it.
2. Click the Add to Array button.
The selected physical drives show "A:new" to indicate the drive has been
added to a new array, but has not been accepted yet.
3. If you want to remove a physical drive from a new array, select the drive
in the new array and click the Reclaim button.