Integrated HP NetRAID Controller Config. Guide

Chapter 6 HP NetRAID Software

Step K. Install NOS-specific Configuration Utility

In this step, you install the configuration utility specific to your NOS.

• If you are using any version of Microsoft Windows NT or Windows 2000,

you install the HP NetRAID Assistant utility. This is the Windows NT

and Windows 2000 version of the utility you used to configure your

system in Chapter 5.

• If you are using Novell NetWare, IBM OS/2, SCO UnixWare, or SCO

OpenServer, you install the HP NetRAID Config utility.

Chapter 10, "Understanding HP NetRAID Utilities," has menu maps of both of

these utilities. For complete information about these utilities, see the

HP NetRAID Series User Guide in Information Assistant.

Install the utility as described for the NOS version below.

Microsoft Windows NT 4.0 and Windows 2000

1. Select Start from the taskbar.

2. Choose Run from the Start menu.

3. Insert diskette #1, "NetRAID Software for Windows."

4. Type <d>:\setup at the Open: prompt, where <d> is the drive letter of

the diskette drive you are using.

5. Follow the on-screen instructions.

NOTE Setup installs the following HP NetRAID Series software:

• HP NetRAID Assistant (nraid.exe)

• HP NetRAID Monitor Service (megaserv.exe)

• HP NetRAID Consistency Check Scheduler

(megactrl.exe)