Integrated HP NetRAID Controller Config. Guide

Chapter 6 HP NetRAID Software
84
◊ You do not need to set the SCSI transfer rate if you are using internal
hot-swap mass storage only, since it is Ultra2.
• To operate in I
2
O mode, set the PCI class code to I2O mode.
NOTE Instead of using HP NetRAID Express Tools to change the
PCI class code, you can use the Set Class utility in the
"NetRAID Software for DOS" utility in the diskette library on
the HP NetServer Navigator CD-ROM. This is faster if you
have multiple HP NetRAID Series adapters because it avoids
multiple restarts of the HP NetServer.
• If you need to prevent booting from the HP NetRAID subsystem,
disable the HP NetRAID BIOS.
HP NetRAID Express Tools is a configuration and management utility that
resides in a chip on the HP NetServer I/O board along with the HP NetRAID
BIOS and firmware. For more information about HP NetRAID Express Tools and
its functions, refer to the HP NetRAID Series User Guide in Information
Assistant.
To Start HP NetRAID Express Tools
1. Boot the host HP NetServer and watch for the flashing message:
Option: Experienced users may press <Ctrl> <M> for
HP NetRAID Express Tools now.
Firmware Initializing
2. While this message is flashing, press <Ctrl> <M>. When the system stops
scanning, HP NetRAID Express Tools starts and displays the Tools
Management menu.