Integrated HP NetRAID Controller Config. Guide

Chapter 6 HP NetRAID Software
86
To Change the PCI Class Code to I2O
To support I
2
O operation, set the PCI class code to I2O on the integrated
HP NetRAID controller and on all HP NetRAID Series adapters in the system,
other than HP NetRAID and HP NetRAID-1 adapters, which do not support I
2
O.
NOTE Instead of using HP NetRAID Express Tools to change the
PCI class code, you can use the Set Class utility in the
"NetRAID Software for DOS" utility in the diskette library on
the HP NetServer Navigator CD-ROM. This is faster if you
have multiple HP NetRAID Series adapters because it avoids
multiple restarts of the HP NetServer.
To use HP NetRAID Express Tools to change the PCI class code, do the
following:
1. If you have installed one or more HP NetRAID Series adapters, select the
integrated controller or an adapter:
◊ Choose Select Adapter from the Tools Management menu.
◊ Select the adapter of interest.
2. Choose Objects from the Tools Management menu.
3. Choose Adapter from the Objects menu.
4. Choose Emulation from the Adapter menu.
5. To change the PCI class code:
◊ Choose PCI Class Code from the Emulation menu. A submenu
appears.
◊ Use the arrow keys to highlight I2O. Press Enter.
◊ Choose Yes to confirm your selection.
6. Restart the HP NetServer when prompted.
To Exit HP NetRAID Express Tools
To exit HP NetRAID Express Tools, press Esc repeatedly until the Exit? prompt
is displayed. Choose Yes. Then press any key to reboot. The new parameters
become effective after you reboot.