HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

Chapter 5 Commands

CE Remove From Configuration

This command removes CEn from the configuration, resets it, and reboots it. When the CE

reboots, it tries to rejoin the server. If you do not want the CE to rejoin the server, power it off

or use the CE Disable Operation command.

Warning: If only one CE is in operation, use a Windows NT Shutdown

command whenever possible. This command does not perform a

normal Windows NT shutdown. As a result, you can lose any data

in the disk cache that has not been written to the disk.

Command CEn Remove From Configuration From IOPx

Console Syntax MTCCONS CEn Remove From Configuration From IOPx

-disable_safeguard

Note: The -disable_safeguard argument is needed only for the last IOP

online or for the CE boot disk if the CE is running.

Variables n – the ID number of the CE (1 or 2)

x – the ID number of the IOP (1 or 2)

Results Check the Windows NT Event Viewer for a message that indicates that the

CE has been shut down, disabled, or removed from service.