HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

Chapter 5 Commands
90
ESI Enable Operation Command
This command enables a faulted ESI (Endurance System Interconnect).
Command ESIn Enable Operation From IOPx
Console Syntax MTCCONS ESIn Enable Operation From IOPx
Variables
n – the ESI’s ID number:
Table 5-5 ESI Data Paths
x – the ID number of the IOP (1 or 2)
Results Check the Windows NT Event Viewer on the CE for the following message:
IOPx.MtcMon status: ESIn has been enabled by operator
request
.
ESI ID Number Data Path Between . . .
11 IOP1 and CE1
12 IOP1 and CE2
21 IOP2 and CE1
22 IOP2 and CE2