HP NetServer AA 6200 Solution Release 3.0 Administrator's Guide

Chapter 5 Commands

IOP Enable Operation

This command enables the specified IOP that was disabled or faulted. The IOP attempts to

rejoin the server immediately or when it reboots Windows NT.

Command IOPn Enable Operation From IOPx

Console Syntax MTCCONS IOPn Enable Operation From IOPx

Variables n – the ID number of the IOP (1 or 2) you want to enable

x – the ID number of the IOP (1 or 2) that issues the enable command

Results To verify that IOPn has been enabled, either:

• Issue an IOP Show Configuration command from either IOP.

• Check the Windows NT Event Viewer on the CE (or on the IOP that you

enabled) for a message that indicates that the IOP is enabled.